Atop ABLELink SW5002 Manuel d'utilisateur télécharger pdf (Page 9)

User manual Version 1.0

SW5002 Wireless Serial Server

- 3 -

2.4. Installation Procedures

 Prepare necessary cables, DC power adapter and RS-232/RS-485 connector.

 Place SW5002 under the access point signal coverage area, or connect SW5002 to Ethernet

cable with RJ45 connector.

 Connect SW5002 serial port to serial device, make sure the connector and wiring of RS-232 or

RS-485 is correct.

 Plug in SW5002 to DC-9-48V power source (with DC-jack or 3-pin terminal bock connector),

buzzer will beep and the RUN LED will blink if SW5002 functions normally. For LED Status sees

Appendix D4

Use Monitor.exe configuration utility on the product CD to check the status of SW5002. If it starts up

successfully, User shall find the IP and MAC address of SW5002. User can change IP address, gateway IP

address and subnet mask networking parameters of SW5002 according to user networking configurations.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 68 69

Pas de commentaire

Atop ABLELink SW5002 Manuel d'utilisateur Page 9