Atop ABLELink MB5000 Series Manuel d'utilisateur télécharger pdf (Page 31)

User manual Version 1.0

Modbus Gateway

Then we will configure the ID Routing between ID 1-10 of Port1 and ID 1-10 of Port2, where the Master ID

will be used to identify the routing between Port1 and Port1. In this example, the Master ID1-10 is routed to

Port1 and Master ID11-20 is routed to Port2. Port1 settings are as below:

Enter Master ID 1-10

Enter Slave ID 1-10

Click to add to the ID list.

After all settings are configured click but do not click “Apply” until Port2 has been

configured.

Port2 settings:

Configure the port parameters:

Port2 uses RS422 and should be set in the Hardware Mode option. Click after settings are

made but do not click Apply until Port2 has been configured.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37

Pas de commentaire

Atop ABLELink MB5000 Series Manuel d'utilisateur Page 31